Got a part finished blade from Rob J Evans in - the middle one here:
He described it as like a Rat Izula knife and I didn't look at the measurements so was a bit surprised when it turned up. The Rat Izula is a lot more petite than this one!
This is a 5mm thick piece of steel and a good handful.
The bevels on it as it arrived were a high flat grind with a thick edge on it still. I couldn't resist convexing the bevels - I didn't get round to taking a picture before I started, unfortunately!
5mm thick, nice wide blade and a convex edge will be a beautiful slicer but strong as anything!
Handle plan is black micarta with stainless steel fittings. Maybe some red liners too.
No comments:
Post a Comment