A blade previously started here:
Two New Blades Started
I have been doing more work on the EN9 blade but have been forgetting to record it.
So I had originally planned a wrought iron bolster. That was taking far too long so I decided to change to brass - much easier to work!!
So this morning I was at this point:
The bolster roughly fits but before I do any more filling, I wanted to cut it down to size.
Hacksaw rough cut:
then grinder to shape. Angled to start with to get the top outline quickly before I rubbed the marker pen away!
and then parallel sides.
The top lines will change at the end. It'll become clear later.
The slow job of getting that fit nice and snug now...
- ► 2016 (13)
- ► 2015 (24)
- ► 2014 (29)
- ► 2013 (37)
- ► 2012 (28)
- ▼ July (4)
Powered by Blogger.